|
15
|
HP-AGILENT
RF Power Sensors
|
|
Please
quote RF Reference No's
when contacting SSE (UK)
|
|
||||||
|
HEWLETT
PACKARD |
WEINSCHEL-AEROFLEX
PRECISION REFERENCE ATTENUATOR |
|||||||||
|
|
|||||||||
|
HP
- AGILENT REFERENCE ATTENUATOR “N”
• Model: 11708A • 50 OHMS • Attenuation: Factory Set to 30 db ± 0.05 db at 50MHz • SWR: < 1.05 at 50MHz • Condition: Some NEW-UNUSED, A1+..!! Some Used, nice. All tested.!! Another Classic HP Attenuator. Used with HP 8484A and Other Sensors from IFR / Marconi / Aeroflex, etc. • Price: New =£110 each, Used = £75 each Click for large photo |
WEINSCHEL-AEROFLEX
PRECISION Reference Attenuator “N” * Model: 5848 * 50 OHMS * RF Power: 5Watts * Attenuation: 30 db ±0.04 db at 50MHz * VSWR: < 1 : 06.1 * Connectors: “N” ( M ) + ( F ) Precision S/S * Condition: NEW - UNUSED, A1+..!! A precision attenuator for use with MARCONI, IFR, AEROFLEX RF Power Meters, 6960-B, etc. Must be used with the 6920 -70 dbm Sensor or the HP 8484 -70 dbm Sensor, during the calibration check with 50MHz 0 dbm, 1mW Output Signal. Click for large photo * Note: A standard 30 db attenuator is NOT accurate enough calibration for a Hp436, 537, 438 or Similar Power meters. * Price: £110 each (6pcs available) |
|||||||||
|
HP-AGILENT
RF Power Sensors
|
||||||||||
|
HP-AGILENT
RF Power Sensor “N” • Model: 8481A • 50 OHMS • Frequency: 100MHz to 18GHz • Connector: “N” Male Precision • RF Power: -30 dbm to +20 dbm (100mW) • Condition: Used, Fully Checked! Calibration Chart Dated 07/2009!! Classic HP Sensor. • Price: £375 (1pc) Click for large photo |
|||||||||
|
HP-AGILENT
RF Power Sensors
|
||||||||||
|
Hewlett
Packard-Agilent RF Power Sensor "N"
• Model: 8484A • 50 OHMS • Frequency: 10MHz to 18GHz • RF Power: -70 dbm to -20 dbm • Connectors: "N" Male Precision S/S • Condition: Used, Fully Tested. • Note: These are very sensitive sensors! A HP or Weinschel, etc. Reference Attenuator should be used for calibration, i.e. 50MHz 1mW (0 dbm) HP435, 436, 437, 438, etc. • Price: £ each (8pcs available) Click for large photo |
|||||||||
|
HP-AGILENT
RF Power Sensors
|
||||||||||
|
|
|||||||||
| Hewlett
Packard - Agilent RF Power Sensor • Model: HP8484A • 50 OHMS • SN: 2046A08323 • Frequency: 10MHz to 18GHz • RF Power: -70 dbm to -20 dbm • Connector: “APC-7” Male • Chart: • Condition: Very nice!! Remember this is a "APC-7" Connector. • Price: £150 Click for large photo |
HP-AGILENT
RF POWER SENSOR + REFERENCE ATTENUATOR (Pair) “N” • Sensor: HP 8481D / 10MHz - 18GHz • Power: -70 dbm to -20 dbm (100pW - 10µW) • Attenuator: HP11708A, 50MHz, 30 db Calibration Reference for 1mW 0 dbm Signal • Condition: As New, A1+..!! Please note this is the MODERN replacement for the classic HP8484A. Due to the sensitivity of the 8481D a HP11708A must be used on the 1mW 0 dbm, 50MHz Calibration Signal. A standard 30 db attenuator is NOT accurate enough. Observe signal Level with this Sensor!! • Price: £400 Click for large photo |
|||||||||
|
HP-AGILENT
RF Power Sensors
|
||||||||||
|
75
OHMS
|
||||||||||
|
Hewlett-Packard-Agilent
RF Power Sensor • Model: 8483A • 75 OHMS • SN: 2701A05113 • Frequency: 100KHz to 2GHz • RF Power: 300mW (AVG) • Connector: "N" ( M ) 75 OHMS • Chart: No • Condition: Very good! • 75 OHMS to - 50 OHM Adaptor available • Price: £190 Click for large photo |
|||||||||
 |
Solid
State Electronics (UK) 6 The Orchard, Bassett Green Village Southampton, SO16 3NA, England. Tel. 02380 769598 or e-mail: solidstate@ssejim.co.uk |
|||||||||
